Technical & Reference Section > Tech and Restoration

Suntour XC-1 beartrap pedals Information needed!

(1/2) > >>

McQUEEN:
Looking for some help on Suntour beartrap pedals -

As I understand it the original pedals were the XC-1s - these came out around 1981 and came with the sharper pointed tooth cage versions without a brace to the cages....

The XC-2s came out around 1982 with a brace to the cages and the cages had a blunter tooth?

Did both versions come with engraved Suntour cage screws?

Thanks

bobafett:

Hmmm.....

As I remember the earlier ones all had the brace. It was the later ones without the brace say 84/85 ish  :-\
I think those later ones may have had non-engraved screws as well at some point.

You are definitely right about the earlier sharp cages but I think they may have ran a little later - see this February 83 BMX Plus review below with the sharp cages :



 :daumenhoch:

chrisv39:
The earlier pedals up to 84/85 alll had braced bodies then changed to the braceless which also had the teeth configured 2/2 on the bodies rather than 3/1. I’ve got 2 pairs of the earlier XCII and both have Suntour stamped screws, I think the later ones were just stamped with an S.

GRAB ON KID:
Hi,not sure where your getting 81' from but you might be thinking of Suntour XC Compes which were the later MTB versions of the MP1000's.The same pedal but w/chromed spindles instead of black,different logos & black cages.

The XC-1's came out in early 83 around the same time as the BMX Plus article Bobafett posted & where stock on Kuwie Lazer Lites.These were braced w/Suntour stamped cage screws as mentioned above.  :daumenhoch:
-Mike

McQUEEN:
Thanks guys, goes to show the internet can be the devils window when it comes to research....

So, braceless was XC-1, out in 83ish with 2/2 teeth on the bodies and suntour stamped cage screws, and XC-2s were braced with 3/1 teeth on the bodies possibly with S stamped on them. Any ideas on the dates that XC-2s became available?

I have two pairs of XC-2s and one pair of XC-1s, but all with XC-2 stamped cages. The XC-1s don't have anything stamped on the screws so I'm guessing these have been retrofitted. One pair of XC-2s have black painted spindles which I'm guessing have also been retrofitted (they were on a survivor that I bought complete).

Navigation

[0] Message Index

[#] Next page