Technical & Reference Section > Tech and Restoration

MX 900 rivets

(1/1)

Hedsta:
Evening chaps...

Im sure this has been covered before whats the best advice re-attaching the rivet that holds the quick release in place on an MX-900?

I know I can get the replacement studs but its the putting them back o that Im stuck with. I've read you need a press and I've read you can do it with a hammer?

Any advice on what size replacement studs I'd need as well would be gratefully received as I've never done this before  :uglystupid2: :uglystupid2:

Thanks in advance as always

Steve

Spen69:
You need a rivet press bud, you'll never do it with a hammer. I'm sure Steve "Animal" made a jig to do them but don't know if he's still got it - would be worth dropping him a pm to see :coolsmiley:

Hedsta:
Thanks bro...wil look him up.

You dont know what size rivets I'd need? I can find them for MX1000's but not sure if the same ones would fit 900's?

Thanks again

Steve :) :)

Avro:
You can do this quite easily with a a rivet snap and hammer. Rivet snaps are cheap:
https://www.ebay.co.uk/itm/Rivet-Snaps-UK-Made-Model-engineering-live-steam-model-loco-traction-engine/330703010063?hash=item4cff6f790f:m:m-5NfQcABYmWIAK0AA8o0UQ

They are simply punches with a concave dimple in the end. From memory I think I used 3/32

Hedsta:
Thats really helpful mate..

Ive ordered one and Ive got a few spare rivets comming so fingers crossed

 fistblump fistblump

Navigation

[0] Message Index