Technical & Reference Section > Tech and Restoration

New school rear brake

<< < (2/3) > >>

Spen69:
Make sure you toe them in a bit when you fit them bud, they squeal like a pig otherwise  :coolsmiley:

They have a direction arrow on them as well, so watch that little gem  ;D

kalex:

--- Quote from: Spen69 on April 25, 2020, 04:31 PM ---Make sure you toe them in a bit when you fit them bud, they squeal like a pig otherwise  :coolsmiley:

They have a direction arrow on them as well, so watch that little gem  ;D

--- End quote ---

Yep I make sure all pads are toe'd  :daumenhoch: but it is a good and valid point as it's a simple one to forget to do.

firedfromthecircus:
I had a similar issue with my 22.
Fitted some kool-stop pads and a tech-77 lever in l/h flavour. Definite improvement and I can now at least lock the back wheel if I want. No chance I was doing that before! All cost a lot less than an Odyssey Evo 2.5 set-up.

kalex:

--- Quote from: firedfromthecircus on April 27, 2020, 10:37 PM ---I had a similar issue with my 22.
Fitted some kool-stop pads and a tech-77 lever in l/h flavour. Definite improvement and I can now at least lock the back wheel if I want. No chance I was doing that before! All cost a lot less than an Odyssey Evo 2.5 set-up.

--- End quote ---

I did look at the tech-77 but I wasn't sure of the quality for some reason.

I haven't done anything yet as been busy in the garden and garage

Bigfrawg:
I run tech77’s on all my builds with clear pads , usually on an ad990 , I’m a fcuking unit and it stops me just fine .

Navigation

[0] Message Index

[#] Next page

[*] Previous page