Technical & Reference Section > Tech and Restoration

se post problem

<< < (2/2)

harris:
yep seat onto post

bodamus:
Dan I have fitted Kashi Aeros to the alloy post and they always stayed tight.

From bodamus.

brass monkey!:

--- Quote from: Mattdub on November 03, 2006, 04:41 PM ---
--- Quote from: monkeybiscuits on November 03, 2006, 04:36 PM ---
--- Quote from: harris on November 03, 2006, 04:35 PM ---just fitted my post to my pk ripper and didnt no about mounting the seat as most posts
are larger will the clamp close up on the seat that much or is it in need of a shim.

--- End quote ---



have you got a pic of the weld? I need to get one fixed myself, any advice?


--- End quote ---



Dan means the seat clamping on the post I think  :daumenhoch:

--- End quote ---


Dan, didn't i read you bought a PK with a snapped seatpost tube? I'm thinking this was the same one??? :-[ :-\ ::)

Note: Get a Uni Hammerhead !
;)

harris:
will try one ,i put a normal seat on and slopped around but i havent tried tightening it up
as the ripper posts are narrow.
mr biscuits i do have another ripper with snapped post tube so its of to get welded

brass monkey!:

--- Quote from: harris on November 03, 2006, 04:46 PM ---will try one ,i put a normal seat on and slopped around but i havent tried tightening it up
as the ripper posts are narrow.
mr biscuits i do have another ripper with snapped post tube so its of to get welded

--- End quote ---

aaah, that's what threw me !

i was blind and now i can see  :LolLolLolLol:

I have a Red NOS Uni Hammerhead, will trade Plus cash for your Crupi Por's if you are interested ? ;)

Navigation

[0] Message Index

[*] Previous page