Technical & Reference Section > Tech and Restoration

Whats is the best way of fitting a bottom bracket

<< < (3/3)

OrgasmDonor:
freeze cups n use a big fook off wooden mallet, and whack the bejesus out of them until somethin gives, i use this technique on all my builds, its fookin terrifyin but effective :daumenhoch:

hooga1975:
I gave up on the vice as it didnt go wide enough.  Whilst rooting around in my old mans shed I found a fook off wooden hammer and smacked the feckers in with it.  Thanks for the tips though fellas :daumenhoch:

login_user:
I used a bit of 10mm threaded studing and 2 planed pieces of hard wood with 10mm holes in them and a couple of nuts and washers.Place a nut and washer on one end of the studing then put the studing through one piece of wood then the bearing cup,the frame,the other piece of wood and then the other nut and washer.Do both the nuts up so it pulls the bearing cup into the frame,then do the other side. Simple :D

Hope that makes sense. :daumenhoch:

OrgasmDonor:

--- Quote from: hooga75 on December 19, 2006, 03:49 PM ---I gave up on the vice as it didnt go wide enough.  Whilst rooting around in my old mans shed I found a fook off wooden hammer and smacked the feckers in with it.  Thanks for the tips though fellas :daumenhoch:

--- End quote ---



Thats ma boy :daumenhoch:

Navigation

[0] Message Index

[*] Previous page