Technical & Reference Section > Tech and Restoration

Profile crank bearing spacer tube?

(1/4) > >>

Moose:
Do they make different lengths?

I have 2 pairs of Profile made GT 3pc cranks and the bearing spacer tube on both sets are too short?  ???

LXIX:
yes europe and usa?

Dingobmxer:
yup they do two lengths BUt are normally too short anyway  :uglystupid2:
what I do is use the thin spacer washers INSIDE the BB to get the correct length
 :) DINGO :)

harris:
yes  moose ,i have other makes the same problem.some people cut them down also
some bb are narrower than others .so you will find they will be good on some frames and not others.
or space them.

LXIX:
  :wtf:  cut a new tube same dia different lenght ,spacers are only for the drive end to get your chain lazer straight,did you people race bikes?

Navigation

[0] Message Index

[#] Next page