Technical & Reference Section > Tech and Restoration

stuck seat post

(1/2) > >>

adiec72:
any smart ideas on how I can get my seatpost out without fooking the frame. Tried WD40 and gentle persuasion but to no avail..?

login_user:

--- Quote from: adiec72 on March 10, 2007, 02:50 PM ---any smart ideas on how I can get my seatpost out without fooking the frame. Tried WD40 and gentle persuasion but to no avail..?

--- End quote ---

Heat it up with a blow torch. but do it gradually so you don't burn the chrome,a bit more care needs to be taken if its paint.  :daumenhoch:

scary_leary:
Just stick your slack c0ck in the top.
Pap it up until hard..
Then get a friend too pull the frame..you should be left with a seatpost swinging between your legs!

motomagII:
 :LolLolLolLol:

stick the post in vice and use the frame as leverage to loosen it .of cut the post off at the seat tube and the hack saw blade inside the frame cut the post in 2 places then screwdriver in with hammer until the post collapses .done this few times takes lot time couple hours but seems to work .then sand paper in there to clean out the bits of rust etc

username:
I had a stuck post, and the best advice I have is until it actually comes out, it seems it is going to be stuck forever - don't give up.

Mine eventually came free after days of not moving. I used tons of oil and bolted a old seatpost in the seat guts and after a lot of bashing got it to move a mm to the side (rotate). Then after more oil and bashing I got it to rotate a mm in the other direction.

It then took about another couple of hours or so of more oil, more bashing and only managing a degree or so extra rotation every now and then - still convinced it would never come out.

I guess that no matter how hard your forcing it, it needs a long time for the oil to seep down into the new gaps you create from the extra degree of rotation.

Navigation

[0] Message Index

[#] Next page