Technical & Reference Section > Tech and Restoration

Sealed Headset Bearings

(1/2) > >>

Wayne Ryder:
Just bought a Standard via eBay. The seller kindly included the sealed bearings on the BB & headset. Trouble is, I've never used one before.
The lower race looks like it'll just accept the curved flange (couldn't resist using that word) at the bottom of the forktube. The top one, I'm not so sure of.
Will the top part of my existing Aheadset  (an FSA Pig, I think) fit the Pig Pro, or would it be easier & cheaper to just transfer the loose-ball stuff over and not use the sealed set?

theRuler:
sounds like an internal headset?

Wayne Ryder:
Is it? Not seen one up close to compare.
The cups are just like a regular headset, maybe a little smaller in the case of the top cup, the only difference are the bearings themselves.

Here's a shot from the auction itself:


Item No. 280087651511 if you fancy a look.

oberonspacefruit:
ive got sealed on mine, your right the only diff is the bearings.

Wayne Ryder:
Cool, then the stuff I've got should slot straight in.
Hate it when a job's held up because of something like that.

Navigation

[0] Message Index

[#] Next page