Technical & Reference Section > Tech and Restoration

PK Ripper........ Do i or Dont i ?

<< < (3/5) > >>

jT Racing:
oh, and a tiny(and i mean tiny) bit of proper thinners will go between tube and post and work as a lubricant, be sure to rinse off straight away!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

region11:
As its in such a good original condition, id leave it  :)

theRuler:
strip it and refinish it. it's only paint. may as well make it look as minty as it deserves to.

scary_leary:
Could you not just drill a hole near the top of the post.
then push a long metal rod through... wide grip, turn and pull

gavking:
Yeah the way I would do it is as scary leary says"""
I normaly empty a can of wd40 down it leave it over night then drill a hole through the top of the post. probs about 8mm if ya can then I put an allen key through that hook it with the end of a long ring spanner and turn. Heat the frame up if you can but not hot just warm.
Then when it turns I put a seat on and twist in the normal way to get it out.
Just done it on a jammed post in my profile frame and it worked straight away.

Navigation

[0] Message Index

[#] Next page

[*] Previous page