Technical & Reference Section > Tech and Restoration

Painting MX1000's

<< < (2/2)

sawzall:
i would get them done in 2 pac,i painted a pair of dx,s and they have lasted really well,but make sure an etch primer is used first :daumenhoch:

Zippy:
The problem I'm going to have is that I need to paint round the rivets on the levers and the quick release mechanism. The other problem is I can't spray them because of the same reason so perhaps I'll spray some paint into the lid and use a model brush to apply it.

QUADROPHENIA:


and the zippy crazy freakin show goes from strength to strength  ;D

SteveG:
I was wondering about the best stuff to do this. I Have got to remove the flaky chrome first though. Powder coat would be nice bit probably too thick. I will try 2 pac I think if I can find somewhere who will put it on for me, unless I can get a small quantity from a supplier.

Rombloke:
do they not sell masking tape in your town then.....

do not even think about a brush finish...they will look shocking....mask up, and use a rattle can.

Dave

Navigation

[0] Message Index

[*] Previous page