Technical & Reference Section > Tech and Restoration

loop tail ripper seat tube replacement (warning lots of pics)

<< < (2/3) > >>

dj_benice:
Top Banana that man  :4_17_5:

lazychubs:
looking good and yep takes a brave man to cut it up lol
my mate used a nice size drill .just slighty over size and drilled the top bit out
then cleaned the welds up before welding the new tube in

double chevron:
Skilled Phil !

Great thread.
Thanks.

SaMAlex:
I have looked into getting this done a tiny bit, is that right that the seat tube isnt a standard stock size bit of tubing? Its crazy if its not, did SE custom make every seat tube for their rippers, and if so, why did they make the Inside Dia smaller than everyone else?

Steve P:
Incredible ... some nice engineering you've done there Phil. Great job  :daumenhoch:

Steve

Navigation

[0] Message Index

[#] Next page

[*] Previous page