Technical & Reference Section > Tech and Restoration

URGENT HELP!

(1/4) > >>

brettnai:
I'm just fitting the headset to my Streetbeat, which is my first build from absolute scratch, I'm petrified of fooking it up.

I've bashed in both headset cups and now wanna fit the other bit (dunno whats its called) to the top of the forks, is there an easy way of doing it? will it just slot over as I tighten it up? or is it another hammer job?

need to know asap, its sat in the garden waiting to be done

ta

RATTY:
The bottom race should be a tight push fit, if not then drop it in boiling water for a minute, then quickly fit, should expand it enough to fit :daumenhoch:

harris:
man ring me before you bash anything else 

brettnai:
Cheers mate
I'll go try!

Moose:
A bit of pipe with a slightly larger bore than that of the fork steerer - try an old hoover pipe (but I think that worked on my new school forks for inch an eighth)?

Navigation

[0] Message Index

[#] Next page