Technical & Reference Section > Tech and Restoration

MX1000's PLEASE HELP

<< < (3/3)

danny silverstreak:
thanks fellas

dordymush:
danny just use the oven pride mate.
nitromors aint no good on anno i've found.
just get a little plastic bag tip a bit in then keep moving the lever about in it.
you'l see when its all off then undr the tap to get the stuff off.
same with the mx brakes.
i've done a few.
wont hurt the quick release.
dont use that fookin caustic stuff though.
the oven prides much safer.

dan-dare:

--- Quote from: OrgasmDonor on June 05, 2007, 04:36 PM ---the rivet drills out easy enough, just dont take it to dan dares house coz he'll give you a hand winding drill and you'l be stood like a fookin loop for a good hour bored to fook, arm achein like fook just waitin for death. speaking from experience of course :LolLolLolLol:

--- End quote ---

You havn't been round for a while Daz!!?? :LolLolLolLol:

OrgasmDonor:

--- Quote from: dan-dare on June 06, 2007, 12:06 PM ---
--- Quote from: OrgasmDonor on June 05, 2007, 04:36 PM ---the rivet drills out easy enough, just dont take it to dan dares house coz he'll give you a hand winding drill and you'l be stood like a fookin loop for a good hour bored to fook, arm achein like fook just waitin for death. speaking from experience of course :LolLolLolLol:

--- End quote ---

You havn't been round for a while Daz!!?? :LolLolLolLol:

--- End quote ---

thats coz ive discovered electricity ;D

munners:
I used oven pride and they look and absolute treat. I stripped them, apart from the Quick release which i left on. Couldnt be arsed to drill through rivet. Like Lee (pkradman) said, they go black but you just polish them back to normal. Even the red dia compe sticker stayed on and didnt fade at all. Well happy with them. I will show you all once its built :daumenhoch:

Navigation

[0] Message Index

[*] Previous page