Technical & Reference Section > Tech and Restoration

round peg square hole

<< < (5/7) > >>

theRuler:
a one inch one wont go the shaft

i will need to use, i reckon

1 1/8th parts, 1" cups, 2 sets of bearings.

oberonspacefruit:
d'oh!!!  wat am i thinking. its too much for my poor brain. draw me a pic when youve done all the hard work.

oberonspacefruit:
anyway i sed 1 1/8

theRuler:

--- Quote from: oberonspacefruit on November 02, 2005, 03:05 PM ---would have to mess with a few headsets to get the right combo, you would need a 4" unthreaded headset, and a dooslem pin

--- End quote ---

i'm not sure i would, you know.

oberonspacefruit:
i beg to differ. dooslem pins have got me out of a tight spot on more than one occasion

Navigation

[0] Message Index

[#] Next page

[*] Previous page