Technical & Reference Section > Tech and Restoration

stuck seat post

<< < (2/3) > >>

rarman1:
i have this prob too,

got an 84 performer chrome off ebay, when i striped it down the seat post was another post over the top of the original, leaving about an inch of post sticking out,

any ideas for this orb ?

ORB:
The only bike I ever failed on was a Performer and oddly enough, it was an 84 Pro Performer.

so, I take it the post s snapped off inside the frame with no pertrusions?

matt:
ts an 82 turbo with original post so i cant maul this baby as im keeping it as a survivor

ORB:
I saved a GT one from a redline that I could not budge.

I went at it with loads of petrol to clean up any of the crap in the tube and left it for a while.

Then went and washed it out with petrol again.

Then I went nuts with penetrating oil and WD40 and left the bike to sit.

Head Bolt out of a Peugeot XU engine, grind off the collar below the 55-Torx head so it only just fits inside the seat post. Once it has gone past the end of the post, move it to the side so it is catching on the lip at the bottom

Attach Slide Hammer.

Evenly tap all the way round over and over again. it will eventually let go.

I it is not out within the hour, more penetrating oil and leave it over night.

Try again next night.

Remember, not a lot of force as you will bugger the seat post at the bottom, and take your time.


(the head bolt out of a Peugeot is not essential, but they are strong and fit correctly)

(i think one from a ford CVH will fit too)

matt:
12    do you want to buy a dog    ;D
welcome back mr orb now give me back my ripper   ;)

Navigation

[0] Message Index

[#] Next page

[*] Previous page