Technical & Reference Section > Tech and Restoration

Redline Proline II

<< < (104/117) > >>

MartyC:

--- Quote from: darkslider on November 13, 2007, 11:25 PM ---OOPS do what with it then? Collectable paper weight or get a good colour match on it.

--- End quote ---

Strip it with oven pride/caustic soda (whichever you prefer - oven pride less dangerous), a really good polish and then if you want it red again, use glass paint  :daumenhoch:

darkslider:
Cheers Marty can I paint oven window with glass paint too? :shocked: Who sell it as well?

gt0733:
re-annoing the stem is possible. the shaft needs to be removed.

darkslider, check my 600a and you will see i used the same glass paint to do the head set. i did paint some DX cranks and they turned out ok, buuuut i didn't spend enough time getting the arms polished to a mirror and every slight blemish could be seen through the translucent paint. actually i was quite surprised how crappy the casting was on those DX's compared to some sugino maxy's i had.

darkslider:
Getting a glimmer of hope that stem can be anodised in anodising thread in Tech and Resto. I've found some bars and am unsure what they are?  Redline oval stamp, other side has like a ball logo possibly a baseball!, and numbers 9.876, they are  25.5" wide,  8.75" high.


Any ideas Proline spotters?

Mattdub:

--- Quote from: darkslider on November 15, 2007, 05:08 AM ---Getting a glimmer of hope that stem can be anodised in anodising thread in Tech and Resto. I've found some bars and am unsure what they are?  Redline oval stamp, other side has like a ball logo possibly a baseball!, and numbers 9.876, they are  25.5" wide,  8.75" high.


Any ideas Proline spotters?

--- End quote ---

Not the Pro size bars unless they've been cut ? .

Navigation

[0] Message Index

[#] Next page

[*] Previous page