Technical & Reference Section > Tech and Restoration

Bars Id Please

<< < (5/5)

ron burgundy:

--- Quote from: FuNMoNsTeR on July 14, 2007, 12:08 PM ---Foook....Yuck.... i feel dirty.....Skipped them today....  >:(

--- End quote ---

I'll have them, they seem like quite a nice bar... cromo, good welds, pro size...  a bit odd.

You shouldn't file them under 'shite' Just cause they aren't made by JMC...

Now get back to that skip and get me bars back ;)

FuNMoNsTeR:
Thanks for the ID m8... I dont rate Landar stuff too highly... i had a few bits from them bitd and they were not up to scratch.
  They are on my Torker at present as it is in need of a set of bars.

Bob_Acid:
job's a good-un ;)

Navigation

[0] Message Index

[*] Previous page