Technical & Reference Section > Tech and Restoration

rattle cans

(1/2) > >>

singlefin70:
ive got a some handlebars that tare pitted and the chrome is off when wire wooled em,thinking of doing a rattle can job on em,also a frame.has anyone got an example of a job done [pics]and any helpful tips would be hugely appreciated........cheers

pickle:
ZED is a good bloke to ask......he's always spraying his bits  ;)

but if you do spray anything then it's all in the preperation, make sure the bits are all washed and dry and have no grease on them, try not to touch them with your fingers as this will leave grease on them.

then primer......top coat........then laquer  :daumenhoch:

zed4130:
prep it mate sand it right down , till its all smooth , get some plasticote under coat from BQ etc , and there colour paint , it works great , t,cut after 2-3 coats, then get some clear coat , will last ages and looks great  :daumenhoch:

Trev:
just get superbikedan to powdercoat em.

theRuler:
if you just want a flat base colour use hammerite spray

get the can warm

make sure the surface is flat and clean

spray in thin layers - don't lash it on

heat is the key - spray in a warm place

once the bars are dry enough to hold, put them in the airing cupboard (or somewhere warm) for a week

Navigation

[0] Message Index

[#] Next page