Technical & Reference Section > Tech and Restoration

tuf neck stem help and mx1000 question

(1/3) > >>

dj_benice:
O.K.  I got this on a torker I bought, unfortunately the top and bottom don't marry up as the bolt on the shaft digs in to the top.  Any ideas if this can be fixed ie rotate the big nut so doesn't dig in, or, is it a case of the top and bottom are from two different stems???  I also got some black mx1000's on the same bike, bit knack like, now the issue is one of the arms on each is bent, can I tap tappity it straight or are they as I think too brittle? pics of stem below for your consideration.

Mattdub:
Tuf Neck mini stem there , if you know a good metal worker/fabricator he could make that bolt head smaller or just undo and see if it will re-tighten in a different place .

Heat the MX arms up ?

dj_benice:
cheers, any tips on removing the bolt, am built like a racing snake ;)

pickle:
you need to eat more of that bacon mate! instead of handing it round  ;)

dj_benice:
 :LolLolLolLol:  according to a woman at work I am only skinny as I never keep still, did a calorie count once, mullered over 20k in a week so not a lack of cal's  :LolLolLolLol:  note to self haribo are not the foundation of a healthy diet

Navigation

[0] Message Index

[#] Next page