Technical & Reference Section > Tech and Restoration

Correct sized allen bolts

<< < (3/4) > >>

bewarethefox:
Just bought them as well Mark,  so thanks for your help fella. I'll post the bike when its finished, superbike dan powdercoated it so he's eager to get some pics up here!! Thanks again.

mark 2:

--- Quote from: bewarethefox on September 03, 2007, 08:21 PM ---Just bought them as well Mark,  so thanks for your help fella. I'll post the bike when its finished, superbike dan powdercoated it so he's eager to get some pics up here!! Thanks again.

--- End quote ---

Anytime :daumenhoch:

look forward to seeing another one of dan's sparklers......

theRuler:
force the M8's in.

it's just a hutch stem ;)

login_user:

--- Quote from: mark j. on September 03, 2007, 07:44 PM ---Don't buy M8! You'll fook up the threads.........5/16 x 1" UNC is what you need.  Standard thread sizes have changed since Hutch stems were made, it all metric now (M8 for example), Unified Coarse Thread is what you need, aka American Standard, for a 5/16 bolt it has 18TPI, M8 would have 20TPI and the pitch of the thread is different (the base of the thread is thicker). The long and short is it'd fook up your stem....

--- End quote ---

As mark says.  :daumenhoch:

bewarethefox:
Well I've ordered a few off Ebay so hopefully the UNC ones will fit in fine. This is what its going on, nearly there:

Navigation

[0] Message Index

[#] Next page

[*] Previous page