Technical & Reference Section > Tech and Restoration

proline crank spindle problem

<< < (2/2)

gt0733:

--- Quote from: darkersomeday on September 22, 2007, 10:03 AM ---try putting the cup/bearing in with the axle in place, this way the axle will "steer" the cup/bearing in and if it tightens up too much you know that the alignment is drifting out,

good luck :daumenhoch:

--- End quote ---

thanks mate, i'm pretty sure thats how i did the last set. this time i thought i'd be smart and press the bearings in first. i lost  :LolLolLolLol:
i hope i can get the bearing out now without hurting it. if not, it's loose ball one piece time  ;D

gt0733:
woohoo, success  :daumenhoch:

i tapped the bearing out (i tell you them cups are soft  :idiot2: ) put the spacer in and tapped the bearing back in. these will do nicely for my rider  ;)

Navigation

[0] Message Index

[*] Previous page