Technical & Reference Section > Tech and Restoration

Tuf Neck stem dismantling

(1/2) > >>

burnaliser:
Is it possible to take a Tuf Neck stem fully to bits? 

And if so, how do i get the main shaft thingy off the bottom block of the stem? ???

MartyC:

--- Quote from: burnaliser on September 25, 2007, 04:11 PM ---Is it possible to take a Tuf Neck stem fully to bits? 

And if so, how do i get the main shaft thingy off the bottom block of the stem? ???

--- End quote ---

Yes you can dismantle them, ideally you need a bearing press type machine to push the shaft out as it won't damage the stem that way  :daumenhoch:

Rombloke:
yes you can, but i gotta ask, why would you want to.

?????

Dave

MartyC:

--- Quote from: Rom Bloke on September 25, 2007, 06:55 PM ---yes you can, but i gotta ask, why would you want to.

?????

Dave

--- End quote ---

Re-Anodising or super polish?

I stripped mine to get it re-anodised and it's come up a treat  :daumenhoch:

CD17:

--- Quote from: MartyC on September 25, 2007, 06:57 PM ---
--- Quote from: Rom Bloke on September 25, 2007, 06:55 PM ---yes you can, but i gotta ask, why would you want to.

?????

Dave

--- End quote ---

Re-Anodising or super polish?

I stripped mine to get it re-anodised and it's come up a treat  :daumenhoch:

--- End quote ---

Any Photo's  ???

Navigation

[0] Message Index

[#] Next page