Technical & Reference Section > Tech and Restoration

MRD bars query ID bars Please New pic added Help !!

<< < (3/8) > >>

dj_benice:

--- Quote from: animal on October 09, 2007, 08:50 PM ---What about Torker? ::)

--- End quote ---

Can't see pic for some reason but I have a set of torkers if you want me to get ya the measurements, proper skinny crossbar on em :)

animal:
Cross Bar is 16mm in diameter or 5/8 of an inch. Could they be any of the above?

dj_benice:

--- Quote from: animal on October 09, 2007, 09:05 PM ---Cross Bar is 16mm in diameter or 5/8 of an inch. Could they be any of the above?

--- End quote ---

Sound like torkers, just measured me crossbar looks bang on 16mm.

animal:
Right a bit more info to c if we can nail these bars down.  ::)

Cross bar width is   295mm
Underside of crossbar to top of clamp tube is   145mm
Width is 28 inches uncut

could somebody measure up some SE's and Hutch to do a comparison? :daumenhoch:

gossa:
I'd say too square at the bottom to be Hutch bars mate.....i still reckon GT's but lets see if someone can identify for sure

Navigation

[0] Message Index

[#] Next page

[*] Previous page