Technical & Reference Section > Tech and Restoration

sq taper crank help

(1/3) > >>

motomagII:
right bb cups in bearings in and acle in with the bobble bit to the drive side screw on the bit that runs on bearings but on the drive side does this have to be all the way on to the thread end where the bobble bit runs round the axle or can i leave it well back to align me chainring with the freewheel?

jT Racing:
and again in english please ???

TwoBobRob:
<snigger>


Kinda hard to digest I'd agree......  :)

motomagII:
right lets try again the axle has ridge running round it that goes to the drive side.the bit that screws onto this then runs on the bearings .does this part need to be screwed on the axle fully to the end of the threaded part.then tighten the other side till smooth and lock with lock nut or can this part on the right be left not fully tightened ,will it move on the thread as pedals go round?any better
?

jT Racing:
yes and yes

Navigation

[0] Message Index

[#] Next page