Technical & Reference Section > Tech and Restoration

Profile Cranks Tool

<< < (2/3) > >>

CD17:
You can just bye a longer bolt than the standard one. just remove the crank arm bolt, fit the longer one, tighten it up & TAP it with a soft face hammer.
But for £14 I brought the correct tool, all it does is knock the spindle through.


Chris

Sanmarcopizza:

--- Quote ---big hammer, and bolt wot screws into spindle....  sandro ses this works, knocks it through the bearings...
--- End quote ---

I think you may have misunderstood something in the past. The bolt that screws into the spindle that I referred to is in fact the correct removal tool. It is just a beefy bolt which has a shoulder that sits on the end of the spindle, thus not putting stress on the threads.

oberonspacefruit:
ooohhhhhhhhhhh  hark at you......."the correct removal too".....BIG BOLT NOT GOOD ENOUGH FOR YOU EH!!!....... GONE ALL HOITY TOITY AVE WE?........




that tool was wot i meant anyway...was just describing it as a big bolt...

oberonspacefruit:
besides i knew youd be sniffing around this thread to correct me soon enough, as you have profile branded on your butt cheeks.........

dordymush:

--- Quote ---
--- End quote ---
as you have profile branded on your butt cheeks
--- Quote ---
--- End quote ---

that made me laugh  ;D.

Navigation

[0] Message Index

[#] Next page

[*] Previous page