Technical & Reference Section > Tech and Restoration

Could I just tighten this up?

<< < (2/4) > >>

dan-dare:
Is it a redline fork?? :)

TwoBobRob:

--- Quote from: S&MAlex on January 23, 2008, 02:48 PM ---I think you will need a .......

Top Hat
The most effec-tu-al Top Hat
Who's intellectual close friends get to call him T. H.
Great for when you need to fill space
Top Hat
The indisputable leader of the gang
He's the boss
He's the VIP
He's a championship
He's the most tip top -  Top Hat

Yes he's the chief
He's the king, but above everything
He's the most tip top - Top Hat!


--- End quote ---



That,  was genius   :4_17_5: :4_17_5: :4_17_5:

I was singing along and everything!


Lots of people just tighten them up and go riding.  I would suggest a good quality 10mm penny washer or similar to spread the load of the smaller nut to help things out.   ;)

scary_leary:

--- Quote from: dan-dare on January 23, 2008, 03:20 PM ---Is it a redline fork?? :) 

--- End quote ---

No Dan a late 80's robinson.
Moose i hear that.. i fitted a 14-10mm in a Gt fork and the forks drops were slightly smaller than 14mm..
was a right ball ache fileing the drops to make it fit.
I think these are the same type of dropout.. fook it as bob said, tighten them with a big washer  :daumenhoch:

Moose:
I'm pretty sure they'll not be 14mm if they're from a late 80's Robo

OrgasmDonor:
a 14mm wont fit thro the slot, a decent washer either side would do it tho

Navigation

[0] Message Index

[#] Next page

[*] Previous page