BMX General > BMX Chat

100+ PSI with Skyway Tuff II's. Any Problems?

<< < (3/6) > >>

OrgasmDonor:
i run 60 psi in my tuffs :daumenhoch:

moley:
Just thinking ahead mate!     I just read in an article that freestylers run with High Pressure these days,  thought they might know something I don't.

At least I know now that sticking 100psi into a tuff is a big no no.  I'm glad I asked now!

In early December I stuck about 50psi in my other coasterless tuff II's and they looked a bit squidgy. They also didn't feel too healthy when I tried a couple of back hops.   I'll check my pump and make sure it is putting the correct pressure in, it could be under-inflated but I doubt it.   I'll use 55-60psi and see if that makes any difference.

Thanks for the advice.

Trev:
a lot of people have said you couldn't have that much pressure in tuffs and the tyre wouldn't stay on at that pressure. but bitd i used to ride with Haro tyres at 80 psi with no problems. i then moved onto Peregrines and ACS and rode with 100psi.  Never had any problems with that either. Maybe I just got lucky.  I used to have them that high as they were better for lots of spinning tricks.  Tricks like McCircles needed a lot of pressure.

lazychubs:
my comp st's blew of my tuffs at 60 psi
but i am 18 odd stone lol

nouseforaname:
The tyre will blow off the wheel while you're pumping it up if you go to that kind of pressure - always has done with me anyway!!!

Navigation

[0] Message Index

[#] Next page

[*] Previous page