BMX General > BMX Chat

pk ripper on the bay

<< < (2/2)

WARDY:

--- Quote from: Waxintaxin on March 12, 2008, 05:52 PM ---Well savable might go for it replace theseat tube fill theholes

--- End quote ---

Where would you get aluminium tubing for seat tube with a 13/16 inside diameter :-\ this would have to be specially made would nt it ? , from a mill , as it would nt be a stock item and thay charge fooking loads to set the dies up and i dont think they ll just do one either, need another fooked ripper :LolLolLolLol:

Haro82:
Somebody on here has replaced a seat tube on a ripper, I remember a thread about it. Very impressive job it was to  :daumenhoch:

snav69:

--- Quote from: Haro82 on March 12, 2008, 06:12 PM ---Somebody on here has replaced a seat tube on a ripper, I remember a thread about it. Very impressive job it was to  :daumenhoch:

--- End quote ---

 :daumenhoch:

http://www.radbmx.co.uk/forum/index.php'topic=35083.0

Paul  :coolsmiley:

MartyC:

--- Quote from: Wardy on March 12, 2008, 05:59 PM ---
--- Quote from: Waxintaxin on March 12, 2008, 05:52 PM ---Well savable might go for it replace theseat tube fill theholes

--- End quote ---

Where would you get aluminium tubing for seat tube with a 13/16 inside diameter :-\ this would have to be specially made would nt it ? , from a mill , as it would nt be a stock item and thay charge fooking loads to set the dies up and i dont think they ll just do one either, need another fooked ripper :LolLolLolLol:

--- End quote ---

Stock size for aluminium tubing; Fuzzynods mate that did Romblokes Haro Resto repairs could do it easily  :daumenhoch:

Navigation

[0] Message Index

[*] Previous page