Technical & Reference Section > Tech and Restoration

HEEEEELLLLLLPPPP

<< < (2/3) > >>

Dark Diggler:
Hammer

SaMAlex:
A big Vice  (no, not like smoking)

danb:

--- Quote from: S&MAlex on April 12, 2008, 08:14 PM ---A big Vice  (no, not like smoking)

--- End quote ---

I've seen people use large G clamps too, use some solid wood behind the bearing cup and against the frame the other side and just do once bearing cup at a time.
A press is better but can cost quite a few ££

wildwood1971:
Freeze the cups over night and then gently hammer them in before they thaw out  :daumenhoch:

lodge:
Copper hammer, coppers softer than the bearing material so doesn't mark em.

Navigation

[0] Message Index

[#] Next page

[*] Previous page