BMX General > BMX Chat

Headset thingy

(1/2) > >>

BmxBandito:
whats the metal part on the frame just above and below where the forks go that hold the bearing in place?

adam01:
head tube

MartyC:
Is this a serious question?  :-\.  Maybe it's the headtube?  :-X

BmxBandito:

--- Quote from: MartyC on June 07, 2008, 03:48 PM ---Is this a serious question?  :-\.  Maybe it's the headtube?  :-X

--- End quote ---


of course its a serious question, its not the head tube its the little metal disc found aboive and below the head tube that hold the racer to the forks

MartyC:

--- Quote from: BmxBandito on June 07, 2008, 03:50 PM ---
--- Quote from: MartyC on June 07, 2008, 03:48 PM ---Is this a serious question?  :-\.  Maybe it's the headtube?  :-X

--- End quote ---


of course its a serious question, its not the head tube its the little metal disc found aboive and below the head tube that hold the racer to the forks

--- End quote ---

My apologies, couldn;t quite make out what you were asking.  The forks are held in the frame by the headset which working from the forkd upwards is made up of a fork race, a bearing race, a bearing cup, a bearing cup, a bearing race, a threaded top race, a washer and finally a threaded lock nut.

Navigation

[0] Message Index

[#] Next page