BMX General > BMX Chat

Installing a headset

<< < (2/3) > >>

Bettyswallocks:

--- Quote from: Strikey on June 21, 2008, 01:44 PM ---
--- Quote from: J.T.Racing on June 21, 2008, 01:43 PM ---i think the BB cups will be a struggle to get in a headset hole ;D

--- End quote ---

 :LolLolLolLol: i didn't notice that  :2funny:

--- End quote ---

I didnt notice that either, but the thread title is installing a headset, think JT may have found the problem...  :LolLolLolLol:

steve Beech TA:


I use a rubber mallet, makes life a little easier. :daumenhoch:

meticulous:
by the time you have pee'd about with a rubber mallet and failed, you will be frantically rumaging through your toolbox for the biggest sledge hammer you can find, then taking a overhead stance leaning your body back as much as you can, you will be taking a fook it i dont care anymore approach. as i often do :2gunsfiring_v1:
 :LolLolLolLol: :LolLolLolLol:

moley:

--- Quote from: J.T.Racing on June 21, 2008, 01:43 PM ---i think the BB cups will be a struggle to get in a headset hole ;D

--- End quote ---

Unless he meant 'Ball Bearing' Cups!!  :LolLolLolLol:

KGB Matt:
Grease the cups place against the headtube top and bottom .

Piece of wood on each cup and a G-clamp ...slowly tighten the G-clamp and ........... it works for me.

Matt

Navigation

[0] Message Index

[#] Next page

[*] Previous page