Technical & Reference Section > Tech and Restoration

Profiles and a Ti spindle!

<< < (2/2)

Sean 2000:

--- Quote from: Lazarou on July 06, 2008, 01:08 AM ---How old are the arms? They do get slightly easier over time.

--- End quote ---

Hmmm, they aint new i know that much!

I'm just concerned about there integrity, dont want the spindle or arms shearing on me mid run.
Dont know wether to put the cromo spindle back in as that fitted very snuggly?

Help  :-\

Lazarou:
Well if it's any consolation i've seen the bosses at either end snap many times, i've also seen them snap halfway up the arm but i've never seen the splines shear off!!

Dark Diggler:
I got some well used profiles with Ti axle off mcnulty about a year ago and thay had the same senario-loose ish arms and no tool required to install, they are finer than a fine thing , I used Ti flush bolts for a while but they were shit as they kept coming undone (could be Ti on Ti combined with looser arm splines  :-\) . Even superglue didn't hold em in  :LolLolLolLol: swapped back to cromo flush bolts and all is well and has been since. Deffo no issues relating to the loose fit when installing though. Hope this helps  :daumenhoch:

Sean 2000:
Cheers Diggler, thats wot i wanted to hear now!  :daumenhoch:

Sean.

Navigation

[0] Message Index

[*] Previous page