Technical & Reference Section > Tech and Restoration

Front wheel spindle problems.

<< < (2/2)

subversion:
Have you tried a 3/8" axle?

se-bmxer:
Hi m8

i have one out of an old SR hub 10mm axle so will fit all open bearing hubs, i'll get it in
the post asap, free  :daumenhoch:

Jai

pickle:
cool there you go mate.........as for my filing effecting the thread?  well i only filed where the forks would fit over the axle, so the axle nut didn't go over that section  :daumenhoch:

southern andy:

--- Quote from: SE-Bmxer on July 11, 2008, 02:50 PM ---Hi m8

i have one out of an old SR hub 10mm axle so will fit all open bearing hubs, i'll get it in
the post asap, free  :daumenhoch:

Jai

--- End quote ---

Cheers jai, you're a star mate.  :4_17_5:

Andy



--- Quote from: pickle on July 11, 2008, 03:06 PM ---cool there you go mate.........as for my filing effecting the thread?  well i only filed where the forks would fit over the axle, so the axle nut didn't go over that section  :daumenhoch:

--- End quote ---

Didn't even think about doing it that way pickle, i was gonna file the whole lot off.  :-[ :-[ :-[ :-[  Many thanks for your help mate.

Andy

OrgasmDonor:
just prise the fork openings wider then hammer them back in again ;D

Navigation

[0] Message Index

[*] Previous page