Technical & Reference Section > Tech and Restoration

fork repair using lead

<< < (3/3)

pkradman:
 :LolLolLolLol: fookin ell health and saftey at its best here ... oh and btw answer to the qestion "where do u get the lead from "  ....... church roofs ffs ! :daumenhoch:

jT Racing:

--- Quote from: gjs on July 14, 2008, 09:33 PM ---what does lead melt at,and how hot is the oven for powder coating :LolLolLolLol:

--- End quote ---

about 350-400 and about 160-180 i think. but i could just be guessing.

double chevron:
Nice clean job Phil.
But what's up when you fit wheels again?
Can they be bolted tightly or will dropouts go back to their original mis-shape ?
Lead is quite a soft material

sawzall:
i will fit a washer before nuts are tightened and its only on a show pony,the lead is usually used on car body work and is quite robust ;) it would also be good for filling large dents that wont pull out,

Navigation

[0] Message Index

[*] Previous page