Technical & Reference Section > Tech and Restoration

After spraying pedals.......

<< < (2/2)

superbikedan:

--- Quote from: DaveMc. on August 04, 2008, 09:12 PM ---
--- Quote from: SuperBikeDan on August 04, 2008, 09:05 PM ---what paint did you use dave :)

--- End quote ---

I was told to use Plasti-kote enamel spray paint...  :-\

i wasn't too fussed about the finish... but they actually turned out ok...

it say's it's thoroughly dry in 3 hour's like??



--- End quote ---

tbh i couldnt advise on plasti-kote, if it was a two pack hen yes it's fine in the oven,

why dont you set the oven to 50 and leave then in for an hour :daumenhoch:

lazychubs:
but if they plastic dont use the oven lol

macky:

--- Quote from: SuperBikeDan on August 04, 2008, 09:28 PM ---
--- Quote from: DaveMc. on August 04, 2008, 09:12 PM ---
--- Quote from: SuperBikeDan on August 04, 2008, 09:05 PM ---what paint did you use dave :)

--- End quote ---

I was told to use Plasti-kote enamel spray paint...  :-\

i wasn't too fussed about the finish... but they actually turned out ok...

it say's it's thoroughly dry in 3 hour's like??



--- End quote ---

tbh i couldnt advise on plasti-kote, if it was a two pack hen yes it's fine in the oven,

why dont you set the oven to 50 and leave then in for an hour :daumenhoch:

--- End quote ---


Yeahh, I'll give that a go!!

Cheer's SBD!!  :daumenhoch:

They're magnesium pedals so they'll be ok!!  ;)


( I only painted them Red so they stand out load's in a vain attempt to land whips!! )  ;D

Navigation

[0] Message Index

[*] Previous page