BMX General > BMX Chat

Help Needed Fitting Knight Kreation Stem to 1 1/8 Landing Gears

<< < (2/2)

kdw712:

--- Quote from: brianp on August 15, 2008, 03:43 PM ---If the tapped holes for the clamping portion come right through the alloy, remove the clamping bolts and thread one of them back in from the opposite end, against a 10pence piece or something that's slid into the slot in the back of the stem to slowly (gently) wedge the stem open a bit before gently whacking it down onto the fork steerer with a fooking big hammer ;)

Brian  :daumenhoch:

--- End quote ---

i've used this method too on my azusa stem

& its much less carnage  :daumenhoch:

thecrooch:
should slide on no probs but if it obv. aint then try the above, once on remember to tighten the preload top cap on the headset before you tighten the stem.  Presuming you have the star nut fitted?

Gary72:
If in doubt, give it a clout :LolLolLolLol:

Dingobmxer:
Landing Gear forks can come up a bit big too so if the stem is spot on size wise its gonna be a squeeze, use the reverse bolt method  :daumenhoch:

 :) DINGO :)

Navigation

[0] Message Index

[*] Previous page