BMX General > BMX Chat

ACS Stoker seats.

<< < (2/3) > >>

MartyC:
You mean these....



They did two versions, one with rails and one with a built in post, same seat though  ;)

SteveG:
I have one on my Redline. They were new out when I built it so got wheels seat and stem to match. Not a brilliant picture though.

southern andy:
Nice Steve, what do you think of the seat mate and what year were they from ?????


Nice Pic Marty.  :daumenhoch:  I'm assuming they are relatively rare now.

SteveG:
Not sure of the year, must have been 82-83 ish.  At the time a lot of people had Uni seats but the ACS one was a bit more comfortable to sit on. My one has been well used and I had to re-rivit the seat onto the post, file and polish all the digs in the seat itself and the post. It seemed better than a Uni in that it fitted properly on most bikes as well and you didn't have to use a shim.
I don't remember seeing another back then but I think there are a few pictures on here somewhere.

I actually restored that bike about 15 years ago, just wish I had looked round and bought some new brakes for it at the time as I bet there were loads around, oh well.

fouronethreeoh!:
Early 80's seat, check the link below

http://martinbike.jalbum.net/Parts/Seats/slides/4539_1.html

Damn good reference site for parts.  :daumenhoch:
Top effort from martin.

Navigation

[0] Message Index

[#] Next page

[*] Previous page