Technical & Reference Section > Tech and Restoration

What's the difference...

<< < (2/2)

BrianP:
Cool, will check these tonight.
I'm guessing you measure them in kinda their "natural" position?

 :daumenhoch:

kdw712:
as greg says its the reach or length of the arms

so prob mounting spindle center to center of the lowest position the pad can sit in  :daumenhoch:




1020's are longer arms basically

Frosty:
the unexpected bonus is of course that you also now know the difference between MX900's and MX1000's! :daumenhoch:

BrianP:
lol, yeah i discovered that difference thanks to the guys on here a while ago too.  :daumenhoch:

only other thing i wish i knew a while ago (read: in the mid 80's!) was that i really shouldn't have used wet n dry to remove the gold anodising from a set of MX1000's.....  :-[

Bp  ;D

Navigation

[0] Message Index

[*] Previous page