Technical & Reference Section > Tech and Restoration

Pots head

(1/3) > >>

telelogic:
Hi Chaps,

I have a profile XL stem,

I bought an ACS hollow bolt so I could do the pots mod.

the ACS bolt is too long, can't cut it cos the thread starts too low,  And also, it's too fat!

anyone know what I need and where I can get one?

Been on Rini's but they don't seem to have what I need.

any help, as always, would be appreciated.   :daumenhoch:

lazychubs:
i think i have a oddy potts mod bolt may be skinnier
pm me ya addy and i wil post it out mon to ya

telelogic:
A Gentleman, a scholar, and an acrobat :daumenhoch:

telelogic:
still looking

JT71:
you're worrying about nowt mate.

drill out the stem the right size, it's 8mm or 10mm. for your acs bolt


then thread the wdege all the way on, hacksaw a bit of the thread off, tidy it up with a file and then when your thread the wedge off it should leave the threads nice and clean so it'll thread back on easy. there should be plenty of thread to cutoff, on the one's i've had there hase been.

or get a flex fighter for your stem so your stem is lifted a touch and leaves room for your bolt.

job done

no stress

enjoy.

kind regards Joe

Navigation

[0] Message Index

[#] Next page