Technical & Reference Section > Tech and Restoration

Why is 'Nitomors' so crap?

<< < (2/3) > >>

lazychubs:
or put it in a clear plastic bag cover ring with mors and seal bag
i stripped a frame this way that was powder coated and that worked a treat

fouronethreeoh!:
Im not much help either, this is the aerospace paint stripper we use at work-Dasic D23V
http://www.dasicinter.com/dasic_aircraft_rem.htm
Good sh1t, will strip just about any paint in a few seconds.

sonic-1:
i must admit a few years ago it use to take anything off , but now it seams to take much longer to even get it bubbling , where it uses to bubble so bad the brush it was put on with would get gumed up just putting it on

oldschool rider:
I just did a set of cranks and a brake caliper, both of them were powdered and after leaving for about 45mins I used a green scourer and it came off no problems and with no effort. I used a paintstripper similar to nitromors but a spanish equivalent and no probs.

Maybe your not leaving the nitromors on for long enough mate that's all I can think of.






Steve.

lazychubs:
and have you got the green tin and not interior stuff as the latter is poop

Navigation

[0] Message Index

[#] Next page

[*] Previous page