Technical & Reference Section > Tech and Restoration

Can I totally strip a coaster hub?

<< < (2/2)

adeshere:
Just remember to put the pads in the right way around

subversion:

--- Quote from: Daletsunami on April 07, 2009, 07:55 PM ---Cheers for that :daumenhoch:

I have managed to get most of it stripped now and have drawn my own diagram on what goes where so I can put it back together but the brake lever is not going nowhere, is that normally the difficult bit?

--- End quote ---

I take it you mean the brake 'arm' which attaches to the chain stay of the frame? If so then this sits over the inner cone of the hub like a spanner would. You just need to hold it to undo the outer lock nut non drive side & it should just come off of the inner cone/race assy. Few taps with a rubber mallet will shift it if it's stuck :daumenhoch:

Navigation

[0] Message Index

[*] Previous page