Technical & Reference Section > Tech and Restoration

Cleaing Gyro Bearings

(1/2) > >>

wildon:
Ok, i got a couple of first gen Odyssey Gyros i was going to clean up, re-finish and use on my builds instead of a couple of Gyro 2's i got.  Problem i got is the bearings in the movable parts in the middle have dirt inside and they do not run too smooth anymore.  Can't take them apart so is there something i could do ... maybe put them in something to eat away at all the grease and dirt etc?
Cheers  :daumenhoch:

Bigfrawg:

soak in wd40  :daumenhoch:

snav69:
Soak them inWD40 or De-Greaser but the problem with those 2 processes is that they will remove the grease from the bearings and i'm not sure if you can regrease them as i haven't seen them ::)

 :coolsmiley:

snav69:
I type tooooo slow  :LolLolLolLol:

wildon:
OK cheers i'll try that ... but yeah i think re-greasing them may be a problem ...  :daumenhoch:

Navigation

[0] Message Index

[#] Next page