Technical & Reference Section > Tech and Restoration

Welcome to the jumble!!

<< < (3/4) > >>

lazychubs:
just noticed they sealed bearings
looks like every thing is there for rears

bigsman:
Confusion reigns  :2funny:

Lazy...the $6m question then how do they go together?  I've spent the day trial fitting bits into wheels and I can't see how its gonna happen  :idiot2:  What bits go with what in in which wheel? lol I am fick!

By the way cheers to the earlier poster for the top hats...I was just about to hit the buy button but then the posts after that made me think am I as well buying full replacement kits...

I have a whole build to do and I'm stuck on the wheels...not good!

Ta folks

lazychubs:
its hard to tell with the picts
but graphite one needs one or two bearings per side
fit one side first then axle then put other bearings on after then there should be a washer and lock nuts

bigsman:

--- Quote from: Lazychubs on April 13, 2009, 08:24 PM ---its hard to tell with the picts
but graphite one needs one or two bearings per side
fit one side first then axle then put other bearings on after then there should be a washer and lock nuts

--- End quote ---

No really with you there man...the graph defo needs bearings both sides.  The options I have on me are 3 diff sizes of sealed bearings as shown in my pic above.  The graph doesn't have the retaining cup for loose bearings like the alloy tuff has so I'm gonna have to go all new on it.  What do you mean when you say say one or two bearings per side?  From placing them up I can see that I have sealed bearings that look like they'll go in each side of the graph (with persuasion!) but they are a diff size on each side is that right?  The next part is getting the 'right' axle in there - the ones I have don't have big enough collars to fill the gap in the hub and it looks to me like there'll be play if I use them.  Clear as mud sorry about that appreciate the help guys :)

Can anyone say if the axles pictured above are compatible or not?  If you need more pics no bother I just don't want to f this up - ta

By the way cheers again for the egay heads-up...bought those top hats...figure that'll get the standard tuff up n running after I canabalise my old burner wheel for its bearings etc  8)

Cheers

lazychubs:
on my new skool graph's the front had 2 bearing's per side both the same diametre
axle had built in collar's i never checked the rear tho so not sure on bearing size's

Navigation

[0] Message Index

[#] Next page

[*] Previous page