Technical & Reference Section > Tech and Restoration

Problems fitting Gyro 2 - Help...!

<< < (5/5)

wildon:
Actually you could use an ACS rotor, they don't take any of the the thread from the forks, they use the stem shaft instead

Wadz:
ive just swapped my gyro2 for  an ACS rotor , now ive got it set up its alot better than the gyro , spins loads smoother and with it combine with the ACS boa caliper the stopping power is fantastic, the only thing with the rotor is that the stem has to sit about 2" out the head set for it to operate, if you can live with bars been slightly higher , i'd bin the gyro and get one (£15 ish)
its got to be cheaper then replacing the forks and will work better. (thats if the head set will go on and tighten correctly with out the gyro.)

Navigation

[0] Message Index

[*] Previous page