Technical & Reference Section > Tech and Restoration

Flippin' ACS Rotor....

(1/2) > >>

g_lamb:
Anyone got any experience of setting up an ACS rotor?

Mine's doing my head in.... :tickedoff:

When I use both hands to slide the rotor up and down the stem shaft the brake caliper and lever work/move. As soon as I try to use the brake with the lever, nada....

It's as if the rotor doesn't want to slide parallel with the stem shaft

I've tried adjusting the upper and lower cables which doesn't make a difference. Same result every time

The pics below show how I've set it up. Don't know if Ive got too much spare stem and whether i need to lower it. I didn't find the destructions that helpful. They certainly weren't idiot proof...  :D

What do we reckon chaps?

I've tried a Gyro 2 BTW and it don't fit coz it's a Torker. 5" steerer tube therefore less fork thread available to fit the upper parts of the headest and the gyro plates, just b4 ne1 suggests it...  ;)

wildon:
you tried greasing the stem shaft?

thebigdog:
Move the top cable mount from where it is to round the side above the bottom one and see if that is ever better

gary4130:
yeah the top +lower cables need to be in line to get a better pull on the brake -the only problem is if you turn your bars +try braking also  >:( .mine i had fitted didn't work very well when bars were turned 180  :P

Redline:
Yeh.. line em up fella... mine works fine when lined up  :daumenhoch:

Navigation

[0] Message Index

[#] Next page