Technical & Reference Section > Tech and Restoration

need seat clamp help

<< < (3/5) > >>

sawzall:
pete rickman made a shim to fit over seat tube which made up the difference
 on seat clamp it was just a bit of tube with a slit in it or take a look on ebay
for a dk split seat clamp made for minis :daumenhoch:

sid1972:
The 1983 Gt mini in BMXMUSEUM has an Dia mx hinged job!

Not sure if its tight or not....

mark 2:
Hold tight, I remember I bought another GT mini years ago with a clamp fitted, it had a split shim fitted inside. Fook knows if I've still got it but I'll go digging....

*UPDATE - Not found it :LolLolLolLol:

It may turn up , my junk room is sky high with unorganised crap. Found 4 mx 1000's, dx's, boxed forklifter stem, a burnished ripper among a ton of other bits....not a bad rummage.  ;)

jT Racing:
found them, there are these tange clamps that are too small for a normal bmx. they measure a little over 20mm inside. one was shoehorned onto a showpony the other is lightly used.
nice blue clamps. LMK if your interested ;)

QUADROPHENIA:


send it down old pal....with the other bits  ;)

Navigation

[0] Message Index

[#] Next page

[*] Previous page