Technical & Reference Section > Tech and Restoration

sprocket help

<< < (2/2)

magna13:

--- Quote from: pickle on August 29, 2009, 08:31 AM ---The sprocket shouldn't need washers on the bolt that holds it Zak.....it should sit flush against the crank arm.
The only washer you might need is the top hat one for the 19mm axle

Does that make sense mate?

--- End quote ---

So it does not need washer's? ohh dear. well needed something there becasue on the DMR Crisis crank, you have an adapter so it can fit on to the spindle flush. the Chainwhel i have is a KinkBikeCo. one that comes on their completes. Compared to my DK 33t sprocket its really thin, when i put the adapter in the DK one, no adapter was showing, and fitted all within the chainring, i put the adapter on the Kink one and there is loads of the adapter showing, when i go to tighten this down to the crank arm, the adapter goes against the arm (as normal) but then when you go to screw the sprocket on theres a huge gap! hence the washers ??? can i get just any top hat washer from a bike shop?

magna13:
plus will it be ok to ride it as i wanna ride it today? ???

Navigation

[0] Message Index

[*] Previous page