Technical & Reference Section > Tech and Restoration

primo power bite removal

(1/2) > >>

Glen:
Do Just hammer like fook on the axle to get it out of the BB?

fouronethreeoh!:
Assuming the arms are off, squirt loads of wd40 in between spindle/bearings, then twat away!
Probably rusted in a bit.

motomagII:
put the crank bolt back in then hit it with hammer so as not to damage the axle .they are quite tight but once moving it gets easier

MartyC:
Poor boiling water over the crank end, alloy expands quicker than steel so you should be able to get some "give" on them  :daumenhoch:

magna13:
Be sure to use a woodne/rubber/plastic mallet as these need alot and i mean of hitting to get off! even with WD40 :daumenhoch:

Navigation

[0] Message Index

[#] Next page