Technical & Reference Section > Tech and Restoration

SUGINO CT CRANK FITTING HELP

(1/7) > >>

Swivel:
Guys, cups are in, drive side is on, bolts are on the non-drive side. Its just the arm fitment to finish it off. It doesn't seem to want to slide on to the axle completely and there's a fair gap between the arm and the bottom bracket. Do I give the arm a wack (worried about getting it off then?), or do I use the bolt and keep tightening that to ease the non-drive arm on to the axle.

Please let us know. I'm in haro building mode! :D

Matt  :daumenhoch:

neiljonarcus:
matt if it gets stuck i have a proppa tool to drift crank arms off ............

Swivel:

--- Quote from: n2cus on November 07, 2009, 10:31 AM ---matt if it gets stuck i have a proppa tool to drift crank arms off ............

--- End quote ---

Ta mate, problem is you're the other side of the world lol  :D

Anyone else know about fitting these cranks please?  :-\

Swivel:
 :-\

Swivel:
Ok just been told on another forum that you put the nut on and keep tightening it up and the arm eases its way on the axle towards the bb, but tried that and it is not budging. And I don't want to overtighten it and risk snapping off the bolt  :-\ anyone else help?  :(

Navigation

[0] Message Index

[#] Next page