Technical & Reference Section > Tech and Restoration

Profile cranks arms seem to suck nowdays

<< < (2/6) > >>

region11:
Done all of that and used the correct profile tool.  I put the arm in a vice just to see if  I could bolt  the arm to the spindle without having to put unnecessary pressure on the frame.  The inside of the crank arm doesn't look bad, but I guess if the splines have just a slight imperfection it will have an effect on installation.

pauldudley:
did you use finish line Ti prep ?

region11:
Plenty of ti pep.  I think I just have a dodgy crank arm.

CD17:
Yeah does sound like a dodgy crank arm, it should not be that hard.

lazychubs:
lucky you mine are real loose and creak like crap mate but i didnt use any grease tho lol

Navigation

[0] Message Index

[#] Next page

[*] Previous page